Software-Based Configuration And Control; Configuration And Control: An Overview; Av Configuration; Control Configuration - Extron electronics HC 404 User Manual

Software-Based
Configuration and
Control
This section of the guide is divided into the following topics:
•
•
•
•

Configuration and Control: an Overview

AV Configuration

The AV and front panel lockout settings for the system can be configured:
•
•
Many settings can be configured using either method (OSD or PCS). Some settings are
available only in the PCS software.

Control Configuration

The control ports of the HCR 102 receiver must be configured before use in order to
recognize and accept commands and pass them on to the controlled device. It can be
configured and controlled via a host computer connected to the same network as the
HCR 102. See
port and cabling to connect the receiver to the network.
•
•
Configuration and Control: an Overview
Downloading the Software and Getting Started
AV Configuration Using PCS Software
Basic Control Configuration
via a host connection through the LAN port or the USB port using PCS software (see
AV Configuration Using PCS Software
by using the on-screen display menu system (see
page 28). For cabling details see
USB connections on page 13.
LAN (IP) connector and LEDs
Configure the receiver by using Toolbelt software and by using Global Configurator
software in GC Professional or GC Plus mode. See the Extron
hardware and software requirements.
The default web page embedded within the receiver provides a means to view general
hardware information, network settings, and, if configured, project information. The
embedded web page can also be used to update the firmware. However, you cannot
configure either the AV settings of the system or the control features of the receiver via
the embedded web page.
HC 404 System • Software-based Configuration and Control
on page 48), or
Using the OSD Menu System
LAN (IP) connector and LEDs
starting on page 18 for details about LAN
on
on page 18 and
website for full system
45