Power Connections - Extron electronics HC 404 User Manual

NOTES:
• If you need additional control options, use Global Configurator to fully
customize the system to configure display control using Ethernet, RS-232
serial, CEC, or IR control, or by using an occupancy sensor.
• The factory default control configuration (the GC configuration file that
comes with the system), including CEC commands, is available within the
Downloads section on the
a "Reset to Factory Defaults" reset, you will need to download this GC
configuration file from the website and upload it to the HCR 102.
Supported CEC commands
CEC commands are derived from the CEC driver file, configured in Global Configurator or
included in the factory-installed configuration, and then stored within the receiver. Actions
configured in Global Configurator can tell the receiver to send CEC commands to the HDMI
output. The HC 404 system supports the following CEC commands:
• power on
• power off
• connection status
• show as active source
For additional details, see the release notes for the Extron Universal Display Driver for HDMI
and CEC, available in HC 404 system product page on the Extron website.

Power Connections

Power input connector — For port locations, see
A
ATTENTION:
•
•
•
•
•
•
•
•
HC 404 product web
• volume up
• volume down
• audio mute toggle
Always use a power supply supplied or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification and may
cause damage to the supply and the unit.
Utilisez toujours une source d'alimentation fournie par Extron.
L'utilisation d'une source d'alimentation non autorisée annule toute conformité
réglementaire et peut endommager la source d'alimentation ainsi que l'unité.
If not provided with a power supply, this product is intended to be supplied by a
UL Listed power source marked "Class 2" or "LPS" and rated output 12 VDC,
minimum 0.5 A (HCT 103) or minimum 2.0 A (HCR 102).
Si le produit n'est pas fourni avec une source d'alimentation, il doit être alimenté
par une source d'alimentation certifié UL de classe 2 ou LPS, avec une tension
nominale 12 Vcc, 0.5 A minimum (HCT 103) ou 2 A minimum (HCR 102).
Unless otherwise stated, the AC/DC adapters are not suitable for use in air
handling spaces or in wall cavities.
Sauf mention contraire, les adaptateurs CA/CC ne conviennent pas à une
utilisation dans les espaces d'aération ou dans les cavités murales.
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to
building structure or similar structure.
Cette installation doit toujours être conforme aux dispositions applicables du
Code américain de l'électricité (National Electrical Code) ANSI/NFPA 70,
article 725, et du Code canadien de l'électricité, partie 1, section 16.
La source d'alimentation ne devra pas être fixée de façon permanente à une
structure de bâtiment ou à une structure similaire.
HC 404 System • Hardware Features and Installation
page. If you perform
• user-defined command
• user-defined string
figure 3, on page 10.
A
20