Network Configuration Via Pcs Software - Extron electronics HC 404 User Manual

Transmitter and receiver collaboration system

Hide thumbs Also See for HC 404:

Table of Contents

IP address — Select and enter the IP Address submenu. Press the left  or

•

right  arrow button to move between and select octets. Press the up  and

down  arrow buttons to change the value in the selected octet.

Subnet mask — Select and enter the Subnet Mask submenu. Press the left 

•

or right  arrow buttons to select an octet of the subnet mask address. Press

the up  and down  arrow buttons to adjust the value of the selected octet.

Default: 255.255.255.0.

Gateway — Select and enter the Gateway submenu. Press the left  or

•

right  arrow buttons to select an octet of the gateway address. Press the up 

and down  arrow buttons to adjust the value of the selected octet.

Default: 0.0.0.0.

Network Configuration via PCS Software

To configure network settings using PCS:

Connect the PC and the LAN port of the HCR 102 receiver (see

and LEDs

Connect the PC to the front panel Config port of the HCR 102 receiver using a USB

type A male to USB mini-B male cable (such as the Extron USB CFG cable).

NOTE: If more than one device on a network shares the same default IP address,

address conflicts prevent connection and IP configuration via TCP/IP connection.

You must use a USB connection in these cases.

Apply power to the PC and the HCR 102.

Open the PCS software. You might need to open the application as an administrator by

right-clicking the PCS icon and selecting Run as administrator. PCS opens to

the Device Discovery page. The Device Discovery process begins automatically.

The page displays a list of all Extron control devices connected to the network via LAN

or to the PC via USB as PCS detects them.

Using the MAC address, locate the desired device (HCR 102) in the list.

on page 18) to the same network.

HC 404 System • Hardware Features and Installation

LAN (IP) connector

Table of Contents