Basic Control Configuration - Extron electronics HC 404 User Manual

Basic Control Configuration

NOTE: GC projects can be created offline and uploaded to the hardware at a later date.
Follow the steps in
page 5. The overall process for setting up the control functions of the HCR 102 receiver
is as follows:
Figure 24.
Setup Checklist: How to Proceed With Installation
Within Global Configurator
(GC Professional or
GC Plus mode):
Create a new GC Professional or GC Plus project
No
Overall Control Configuration Steps
HC 404 System • Software-based Configuration and Control
Configure the IP settings of
the HCR 102 and any optional
TouchLink Pro touchpanels.
If desired or required, install a new
security certi cate (via Toolbelt).
and add the HCR 102 to it.
Will
TouchLink Pro
touchpanels be
used?
Create GUI layouts for the
touchpanels or other interfaces:
1. Start GUI Designer.
2. Create GUI layout designs for each
TouchLink Pro touchpanel.
3. Save and build the GUI layout le.
Or...
Download existing GUI layouts
from identical touchpanels.
Con gure ports on the
HCR 102.
Create monitors, schedules, timers,
macros, and local variables.
Add touchpanels (if used)
to the project.
Import GUI layouts and
con gure the touchpanels.
Save the project.
Build and upload the con guration to
the HCR 102.
Test the system, make adjustments,
nalize con guration.
starting on
See Network Network
Communication Setup Communication Setup
in this guide.
Yes
52