Panels And Features; Front Panel Features - Extron electronics HC 404 Setup Manual

Panels and Features

Front Panel Features

HCT 103
HCR 102
R
CONFIG
I J A
Figure 3. HCT 103 Front Panel (Top)
HCR 102 Front Panel (Middle),
HCT 102 D Front Panel Without Wallplate
(Bottom, Right)
A
Configuration (Config) connector (USB mini-B), page 13
B
Input selection buttons
C
Input signal presence (Signal)
D
HDCP status LEDs, page 16
E
Audio input type LEDs
F
Menu button,
G
Enter button, and
H
Navigation (right , left , up , and down  arrow)
buttons (see To configure the AV settings using the OSD
and front panel buttons:
I
Power LED (HCT 102 D), power and reset indicator LED
(HCR 102) (see below)
J
Reset button
(HCR 102) (see below and page 17)
K
Auto Switch LED (see below)
L
Service connector (for use by Extron support staff)
J Reset button (HCR 102) — Pressing this recessed button causes various product settings to be reset to the factory defaults
(see Reset Modes: a Brief Summary
I Reset and power LED— This green LED indicates either the power status of the HCT 102 D transmitter or the HCR 102
receiver, or the reset mode of the receiver. LED indications are as follows:
HCT 102 D Transmitter
• Off — The unit is not powered on.
• On, lit amber — The unit is powered on
but there is no active signal at that input.
• On, lit green — The unit is powered on
and there is an active signal at that input.
K Auto Switch LED — This LED on the HCT 102 D lights green if either of the auto-switching modes is enabled, and it turns off
if both of the auto-switch modes are disabled. For details on auto-switching modes, see the HC 400 Series User Guide.
B
INPUTS
2 3
C
INPUT
SIGNAL
1
HDCP
B D
and LEDs, page 16
LEDs, page 16
(LPCM-2Ch and Multi-Ch, page 16
on page 9)
on page 17).
HCR 102 Receiver
•
•
•
For full descriptions of reset modes, how to use the reset button to activate
them, and details of LED indications of each mode, see the HC 400 Series
User Guide.
C
2 3
4
SIGNAL
HDCP
MENU
AUDIO
1
LPCM-2CH
MULTI-CH
ENTER
E FG
I
Input
1
HCT 102 D Front (Without Wallplate)
NOTE: For AV connectors on the HCT 102 D, see
Rear and Side Panel Features
Off — The unit is not powered on.
On, lit steadily — The unit is powered on.
Blinking — The unit is powering up or the HCR 102 is performing a
reset. The blink pattern depends on the selected reset mode.
4
HCT 103
D
HOLD FOR 720p/1080p
HCR 102
H
K D
AUTO SW
AUDIO IN
AUDIO IN
HDCP
VGA IN
HDMI IN
SERVICE
Extron
L
on page 4.
I
Input
2
3