Edid On The Hdmi And Displayport Inputs; Using Hdmi/Displayport Switchers With The Projector - Digital Projection INSIGHT Dual Laser 4K Series Installation And Quick Start Manual

Digital Projection INSIGHT Dual Laser 4K Series

EDID on the HDMI and DisplayPort inputs

If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself to suit
the projector.
Otherwise please refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector
or the nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.

Using HDMI/DisplayPort switchers with the projector

When using an HDMI/DisplayPort source switcher with the projector, it is important to set the switcher so that it passes the projector EDID
through to the source devices. If this is not done, the projector may not be able to lock to the source or display the source correctly as its
video output timings may not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode.
See your switcher's manual for information on how to set this mode.
Additionally, sources which use HDCP encryption may not display properly when connected to the projector via a switcher. Refer to the
switcher's manual for more information.
Sources
1
Switcher
2
Projector
3
Connection Guide
1 2
EDID
EDID
EDID
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
EDID
Notes
Rev A October 2017
page 24