Procedure To Ignore The Configuration - Teldat Atlas 250 Installation Manual

3 Description of the equipment
Location of the micro-switches
Fig. 13:
Note
To ensure correct operating procedures, all the micro-switches must be in the OFF position.

3.2.1 Procedure to ignore the configuration

Follow the steps below if you have to discard the whole configuration of the device (for instance, if you cannot re-
member the password).
• Turn off the device through the ON/OFF switch.
• Using a screwdriver or another sharp instrument, move micro-switch '5' to the ON position.
• Turn the device on with the ON/OFF switch.
When the device is switched on, a message similar to the one shown below will appear on the configuration console:
**************************************************
******************* Router Teldat ****************
**************************************************
BOOT CODE VERSION: 01.02
gzip Dec 28 2004 12:56:29
P.C.B.: 72
START FROM FLASH
BIOS CODE DUMP..................
BIOS DATA DUMP...
End of BIOS dump
===========================================================
BIOS TELDAT
===========================================================
BIOS CODE VERSION: 01.02
10
Dec 28 2004 12:56:28
MASK:0064 Microcode:002D
(c)Teldat
Teldat S.A.
Atlas 250