Eliwell TelevisGo User Manual page 37

The following commands are presented at the top (E):
• Add or
:
• Remove or :
• Edit or :
• Save or
:
• Cancel or :
• Preview or :
Click Add ( ) or Edit (
) to activate the right-hand part of the window; you will be able to enter all interaction details involving
actions, intervals, alarms and devices. Click Save or
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
The following controls will be visible:
• Name* :
• Enabled:
• Scale:
• :
• :
• level:
In the event of an Alarm, the system will check whether it is managed, on which device it occurred, whether it belongs to a valid
category and if it was activated during a valid interval. If all conditions have occurred, the actions set in the valid alarm categories
will take place in accordance with a level-based system.
TelevisGo always and exclusively takes valid categories into account, and always begins at the lowest-level categories (level 4).
If there are several categories at the same level, the device will perform them all.
Once the Level 4 category actions are complete (if applicable), if at least one Level 4 category has the "Scale" box (H) selected, the
system will check for higher-level categories and carry out the procedures as required.
The same applies to the other levels.
NOTE: 1) If the "Scale" box has not been selected, the device will only carry out the category procedures for the level
reached.
2) If the "Scale" box has been selected in a Level 4 category but there are no valid Level 3 or Level 2
categories, just Level 1 categories, the system will move directly on to the highest level.
Depending on the box in which data is being entered, the following information is required:
A - Actions:
The box displays a list of actions set previously (see paragraph entitled "Actions").
Actions to be performed can be selected using the corresponding boxes on the left-hand side.
B -Time intervals:
The box displays a list of time intervals set previously (see paragraph entitled "Time intervals").
"Valid to/from" intervals for the alarm category can be selected using the corresponding boxes on the left-hand side.
C - Devices:
The window can be used to select one of the following device options:
• ALL:
Select all network devices.
• SELECT: Select one or more specific devices. At this point, save the changes by clicking Save or
selection in XML language will appear in box B1.
Click Cancel or
TelevisGo
To add a new action.
To remove an action saved previously.
To modify an action saved previously.
To save changes made.
To cancel changes made.
To open a new page listing all devices associated with the filters.
to save the new alarm category, click Cancel or
to set the name to be assigned to the alarm category (G)
to enable/disable the "Alarm Category" (H)
to enable or disable the checking of higher levels (H)
to establish whether the following have been selected in box C:
ALL
=
SELECT =
to establish whether the following have been selected in box D:
ALL
=
SELECT =
depending on the content of boxes C and D, an alarm category is assigned a level from 1 to 4.
The following 4 levels can be assigned:
Level
Level 1
Level 2
Level 3
Level 4
to cancel the changes made.
(all devices selected)
(specific devices selected)
(all alarms selected)
(specific alarms selected)
Box C
All
All
Select
Select
to exit without saving.
Box D
All
Select
All
Select
; a translation of the
Page 37/68