Table of Contents
Advertisement
5. INSTALLATION / MAINTENANCE
To install TelevisGo, you have to set up the device and the network of devices it is connected to first.
This can be done via the WEB interface.
NOTE1: Before scanning the network with TelevisGo, each device in the network must be assigned a unique address by
setting parameters "FAA" and "dEA" (family:device).
NOTE2: On plugging in, TelevisGo does not switch on immediately as some checks are run automatically and the software
is loaded (takes about 30 seconds).
5.1 DEVICE SETTINGS
5.1.1 SETTING DATE&TIME
To set the plant name and date & time in the device, go to:
Computer
To access this section, data logging must be suspended (see Data Logging section).
In the window that opens, click the
Now you can enter the date and time then click the
The date and time can be imported directly from your computer by clicking the "Use client date/time" button.
Click the
icon or Cancel to exit without saving the changes.
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
IMPORTANT: Changing the date/time may cause your Web session to expire. In this case, you may need to re-connect.
5.1.2 ENTERING THE PLANT NAME
To set the plant name in the device, go to:
Computer
In the window that opens, click the
You can now enter the Plant name then click the
icon or Cancel to exit without saving the changes.
Click the
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
5.1.3 SETTING NETWORK IP/DNS
To set the network IP/DNS, go to:
Computer
In the window that opens, click the
TelevisGo
Information
General
icon or Edit.
icon or Save.
Information
General
icon or Edit.
icon or Save.
Information
Network Settings
icon or Edit.
Page 16/68
Advertisement
Table of Contents
