Eliwell TelevisGo User Manual page 23

The following page is displayed when Alarms is clicked:
Alarms
System TelevisTwin
Reboot the system in order to make the new settings active.
General
Alarms - Retry interval
00:01:00
Alarms - Retry duration
01:00:00
Alarms - Emergency recipient
sms: +390000000
SMS
SMS alphabet
Modem signal strength lower alarm threshold (%)
Email server configuration
e-mail - Server - Address
e-mail - Server - Port
e-mail - Server - Sender address
e-mail - Server - Authentication required
e-mail - Account - Name
e-mail - Account - Password
In "Alarms" you can set the following
1) GENERAL:
• Alarms - Retry interval:
• Alarms - Retry duration:
• Alarms - Emergency recipient:
2) TXT:
• TXT alphabet:
• Lower model signal threshold alarm (%):
3) Email server address configuration:
• Email - Server - Address:
• Email - Server - Port:
• Email - Server - Sender's address:
• Email - Server - Authentication request:
• Email - Account - Nome:
• Email - Account - Password:
The "Media" card is described in the "Alarm Management" section.
Test Utility sections are shown on the right: here users can check instantly if the settings applied are correct and working properly.
TelevisGo
Media
[0 seconds .. 30 days]
[0 seconds .. 30 days]
Standard 7 bit
40
[1 .. 100]
25
[1 .. 65535]
Copy sender address
Cancel
Edit Save
Page last update on: 7.39.34
to set the interval between 2 consecutive attempts to send an alarm.
(see section entitled "Alarm management")
to set the maximum interval in which to attempt to send an alarm.
(see section entitled "Alarm management")
to set the telephone number to which an emergency TXT will be sent should
the TelevisGo database becomes corrupted and the recipients set by the user
are no longer available.
to set the kind of alphabet you want to use when sending TXT messages.
Standard 7 bit (default) or UCS2 or Cyrillic 7 bit.
by default it is set to "7 bit"
to set the minimum modem signal threshold (as a percentage) which must be
reached before a "Modem signal insufficient" alarm is activated.
to set the email server address.
to set the email server connection port.
to set the sender's email address.
to tell the system whether an authentication request is required
(tick the box if the Server requires authentication).
to set the user name (if authentication is required).
to set the user password (if authentication is required).
Test utility
Message
Test SMS from TelevisComp
Telephone number
+390000000
Signal strength: Not available
SMS Phone
Test utility
Message
Test email from TelevisComp
Address change@email.address
Email
Page 23/68