Table of Contents
Advertisement
Icon
Meaning
Move the selector up a position.
Move the selector down a position.
Add a child rule (selector > interface; interface > device;device> resource)
Modify selector or rule
Delete selector or rule and all sub-rules.
A filter consists of at least one selector. Each selector identifies a specific sub-group of resources and can be additive or subtractive.
An additive selector adds the resources it has filtered to the final assembly whereas a subtractive selector removes the resources it
has filtered. Selector order is therefore significant. A subtractive filter only makes sense when used to filter the result of the additive
filter before it.
To modify a selector, click the relative
Filter
Type
Add
Resources
Analog
Digital
State
Alarm
Save
To create a rule at the network interface level, click the
properties, click the
icon of the rule you have just created. The following boxes opens on the right of the screen:
Quick
Attribute
--- Select ---
Value
Set value
Filter
ID
Name
Save
To create a rule at the device level, click the
click the
icon of the rule you have just created. The following boxes opens on the right of the screen:
TelevisGo
icon. The following box opens on the right of the screen:
The Type can have add (additive selector) or remove (subtractive
selector) values.
A selector also allows you to quickly select all Resources in the current
configuration that belong to one or more types of resource.
Once all changes have been made to selector properties, click Save.
icon for the selector that you want to add the rule to. To modify the
The Filter (below) has two attributes that can be used to define the rule.
The ID field filters interfaces by their identification number. It only
accepts combinations of numbers and ? (question mark) and * (asterisk)
jolly characters.
The Name field filters interfaces by their name. It only accepts special
character combinations which are:
• An IP address with jolly characters (192.168.*.*)
• In the format COMxxx where xxx is a combination of numbers and
jolly characters (COM?)
• The 'Logical' text (the logical interface of TelevisGo).
The Rapid (top) box allows you to set the two ID and Name attributes
by selecting values on the basis of the interfaces present in the current
configuration.
Select the Attribute you want to assign a value to, select a value from
those listed, then click the Set Value key. The field in the Filter area will
assume this value.
Once all changes have been made to selector properties, click Save.
icon for the interface rule that you want to add the rule to. To modify the properties,
Page 31/68
Advertisement
Table of Contents
