Naming Network Devices From File; Setting The Data Logging Interval - Eliwell TelevisGo User Manual

5.2.4 NAMING NETWORK DEVICES FROM FILE

Network devices can be named by applying the settings in a specific xml file generated by the Offline Configurator application (see
the associated manual).
Go to:
Settings
Filter devices
Select a device template
Description
File to be loaded
Filter resources
Device template
Analogue inputs
Digital Inputs
States
Select devices
Alarms
Show helpers
Interface
Show table header
LAN Adapter
Legend
Name
Legend
%
Compact
The page is very similar to the one in Naming Network Devices Manually or From File, as regards both the device and associated
functions (for the meaning of many controls).
The file and settings to be applied can be selected in the File to load (A) box.
Clicking Run will load the template and make it available in the drop-down menu (D).
Clicking the Apply (C) button will apply the current template settings (D) to all network devices selected via the check box to the
left of the name (B).
The following buttons are presented at the top:
Select All: to select all devices in the list.
•
Deselect All: to deselect all devices in the list.
•
Expand All: to view all devices in the interface.
•
• Collapse All: to hide all devices in the interface.
Cancel Filters: to cancel all filters applied.
•

5.2.5 SETTING THE DATA LOGGING INTERVAL

A data logging interval must be set. The time set (in minutes) is the interval (sample) in which data from the selected resource will be
logged.
Data on Statuses, Alarms and Digital Inputs is not logged in this interval. In these cases, data is recorded when these parameters
change and not over a set interval. To set the interval, go to:
Settings
To access this section, data logging must be suspended (see Data Logging section).
On opening this menu, click "Saved data-logging interval in archive", then click the
(hours:minutes:seconds) and click the
For expert USERS: in
Settings
the "Maximum Capacity" (CM) (maximum memory used to save data) is set at 7GB; users can also set the "part of data
archive to be used for circularity" (%CA) (percentage of memory freed when oldest data is deleted each time the
memory reaches full capacity).
The factory-set value is: %CA = 12%.
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
The device will now show the summary in:
Settings
TelevisGo
Interfaces
Select all Deselect all
$
Execute
Browse...
(.xml)
'
ID
0
0.02:00 ID 974LX
0.02:01 ID 974LX
999
999.14:14 TelevisCompact
Data Archive
icon or Save.
Data Archive
Data archive
Device Template
Expand all Collapse all
Address
192.168.0.1
Control
Manage
Summary
&
Cancel filters Apply
Devices
15
1
icon or Edit, enter the number
Page 21/68