TelevisIn & TelevisOut
Data acquisition and alarm signalling modules.
Parametric controller to capture plant variables in real time and signal alarm conditions when connectd to a supervisor system, both
dedicated (Televis) or standard market ones (MODBUS protocol).
UP
DOWN
UP
• Increase values
• Go to next label
DOWN
• Decrease values
• Go to previous label
ON/OFF
+
Pressing and holding these keys at the same time
for 5 seconds or a remote command activates the
ON/OFF function.
In OFF mode, the screen shows the word OFF.
All alarms are disabled, including active and
communication ones.
Probe data capture remains active.
Icon
Description
Permanently on: alarm active and output set for this alarm
Flashing:
Blinks when serial communication is on
NOT USED
ON when the device is powered on but not when it is OFF
NOT USED
NOT USED
NOT USED
Temperature unit of measurement
Pressure unit of measurement
Units of measure for relative humidity
Permanently on: during navigation
Flashing:
Manages utilities connected to the device.
TelevisIn:
indicates if Digital Inputs are active (ON)
(1) ... (7)
TelevisOut: indicates if Digital Outputs are active (ON)
EN
1
alarm silenced and output set for this alarm
alarm active and output not set for this alarm
keypad locked
USER INTERFACE
2
3
4
5
6
7
KEYS
+
LED
esc
set
ESC
• Exit without saving new settings
• Go back to previous level
SET (ENTER)
• Confirm value / exit and save new settings.
• Go to next level (access to folder, sub-folder,
parameter, value)
• Open State Menu
LOCK
Pressing and holding both keys together for
5 seconds or a Supervisor command locks /
unlocks the keypad.
The icon
blinks when the keypad is locked;
nothing will happen when a key is pressed, not
even the setpoint will be displayed.
Colour Note
red
silenced from remote and/or DI
green
green
green
green
green
red
red
red
red
red
Amber
ESC
SET
(ENTER)