Table of Contents
Advertisement
6.2.1 SETTING UP/SENDING ALARM MESSAGES
All switches to alarm condition are recorded, except for when a delay time has been set up and the alarm itself did not persist for
longer than the time set in the delay.
This delay time can be set in the configuration panel for network devices (see section entitled Installation/Maintenance - "Naming
Network Devices Manually or from File"):
from here you can pick which alarms should be signaled and when.
If the list of recipients has been defined, when an error condition arises TelevisGo will store it and send a message in accordance
with the rules established in the relative section (see the "Recipient Configuration" section).
6.2.2 RECIPIENT CONFIGURATION
6.2.2.1 SUMMARY
To view the alarm categories, go to:
Settings
All "Alarm categories" entered will be displayed. The following page opens:
View
Alarm categories
Alarm categories
Level
1
6.2.2.2 ALARM CATEGORIES
To set the alarm categories, go to:
Settings
To access this section, data logging must be suspended (see Data Logging section).
A window like this will open:
Alarm categories
View
Alarm categories
Name
Level
F
universal
1
All "Alarm Categories" set will be shown in the box on the left (F).
TelevisGo
Alarms
Summary
Actions
Time intervals
Escalate
Name
Universal
Alarms
Alarm Categories
Actions
Time intervals
Add
Details
G
Name*
H
Enabled
Escalate
Actions and Time intervals
A
Actions
SMS - Installer A
SMS - Technical Support
Email - Technical Support
Filters
C
Devices
Select all
Get from list...
<inferiore
id="0">
<device
address="02:00"/>
<device
address="02:01"/>
<interface/>
Actions
SMS - Technical Support
Page last update on: 7.39.34
Remove
Edit
Save
Cancel
Level: 1
Time intervals
Alarms
B1
Page last update on: 7.39.34
Time intervals
Daily (MON/0.00 > SUN/23.59)
E
Preview
B
Always
Daily
D
Select all
Get from list...
<resource
id="ALM00166"/>
<resource
id="ALM00300"/>
<resource
id="ALM00301"/>
B2
Page 36/68
Advertisement
Table of Contents
