Table of Contents
Advertisement
5.2.3 NAMING NETWORK DEVICES MANUALLY OR FROM FILE
To name a network device manually, go to:
Settings
The following page opens:
Filter devices
Description
I
Filter resources
Analogue inputs
Digital Inputs
L
States
Alarms
Show helpers
Show table header
M
Legend
Legend
Devices viewed can be filtered by Description (or part description) (I) or by type via Device Filters (L).
Clicking the Cancel Filters (H) button will reset all filters defined (all device filters enabled).
The table heading and key (M) can be viewed/hidden.
Press button F to expand the list of devices present in the network.
In boxes A and B the device can be associated to an "Extended Name" (A - Alias) and a "Short Name" (B - Short Alias). Both can
be up to 25 characters long. You will need the "Short Name" to manage TXT messages.
Valid characters:
•
Upper case (A, B, C, ...)
•
Lower case (a, b, c, ...)
•
Numbers (1, 2, 3, ...)
•
Some special characters (: , - , _ , <space>)
Press button G to expand the list of resources belonging to the device.
In boxes C and D, an "Alias" (C) and a "Alias (short)" (D) can be associated, using the same rules applied to the device Description
and Alias.
If the resource is an alarm, box E opens. The "Delay time" (Tr) before which an alarm will be signaled can be entered in this box (the
alarm doesn't generate an alarm message/alert if it is shorter than the Tr time set (in minutes). This alarm will not be shown in the
alarm screen).
icon or Save (H) to save all data entered or changes made.
Click the
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
N.B.: The devices also include the TelevisGo with all its resources.
There are two icons on the status bar, the function of which is:
•
Capture naming snapshot (H): to save naming settings and network alarm delays in TelevisGo.
Clicking this button opens the file automatically (in .xml format) with the saved settings, allowing users to save a backup
file.
IMPORTANT: using the
The browser may issue a warning message asking you to confirm if you want to download the file; this depends on
your browser security settings.
Network devices can be named by applying the settings listed in an xml file generated by the OfflineConfigurator application (see the
associated manual) or saved via the Capture naming snapshot function (H):
•
The file and settings to be applied can be selected in the File to load (N) box.
•
Clicking Run applies settings to all network devices matching the rules contained in the xml file.
TelevisGo
Interfaces
Expand all
Collapse all
Network naming rules
File to be loaded
Browse...
(.xml)
Select devices
Interface
ID
LAN Adapter
0
Name
0.02:00 ID 974LX
Nome
Analog input 1
Door
Alarm output
Compressor 1
Defrost 1
Evaporator fans 1
Door open
NOLINK
Analog input fault 1
Exceeded the high Input threshold 1
Exceeded the low Input threshold 1
0.02:01 ID 974LX
Compact
999
Nome
Alias
999.14:14 TelevisCompact
icon to save settings overwrites any previously saved information.
Naming
Save
Cancel
Cancel filters
Take naming snapshot
N
Execute
Address
192.168.0.1
Alias
A
Alias (short)
Resources
7
H
Devices
15
Alias (short)
Resources
B
11
Alias
Delay
Alias
(short)
(minutes)
C
D
E
0
0
0
0
0
11
1
F
G
Page 20/68
Advertisement
Table of Contents
