Chapter 9 Hint Information - EDAN SE-1515 User Manual

SE-1515 PC ECG User Manual

Chapter 9 Hint Information

Hint information and the corresponding causes provided by the system are listed as follows:
Hint Information
Lead off: X
No sentinel detected!
No sampling box detected, enter DEMO
display?
Communication failure: Please check
whether the USB cable is connected. You
can reconnect the USB cable and try it
again.
Battery of sampling device is weak,
please change the battery after the test.
Battery is weak, the sampling device is
closing.
Sampling Device is in sleep mode, please
press "Power" to activate it.
Overload
Fail to create database!
The current HR has exceeded the target
HR!
The diastolic BP has exceeded the
normal range!
The systolic BP has exceeded the normal
range!
Table 9-1 Hint Information and Causes
Electrodes fall off the patient or the patient cable
falls off the ECG sampling box.
The sentinel is not inserted.
The software is started without connecting the
sampling box.
The
communication between the ECG sampling box
and the serial port is interrupted.
1. Reconnect the ECG sampling box to the PC.
2. Click on the Device tab in the System Setting
window of the SE-1515 system, and check
whether the sampling device is set correctly.
3. The USB cable falls off the PC during the
sampling process.
Battery of DX12 transmitter is low.
Battery of DX12 transmitter is low.
DX12 transmitter is in sleep mode.
The direct current offset voltage on an electrode is
too high.
The system fails to create database.
Current heart rate value exceeds the target heart
rate value.
Diastolic blood pressure exceeds the normal BP
range.
Systolic blood pressure exceeds the normal BP
range.
- 84 -
Causes
USB cable is disconnected
Hint Information
or the