Table of Contents
Advertisement
SE-1010 PC ECG User Manual
Chapter 10 Hint Information
Hint information and the corresponding causes provided by the system are listed as follows.
Hint Information
Lead off: X
It is pre-sampling now, please click on 'Start' to
begin recording.
Can't find the sentinel!
The sentinel setting is wrong!
Hint: Please make sure the USB line has been
connected. If possible, please re-connect it!
Overload
Fail to open the treadmill (ergometer) port!
Please make sure the treadmill (ergometer) has
been connected to the computer and the port
setting is right
Fail to open the BP monitor port! Please make
sure the BP monitor has been connected to the
computer and the Port set is right!
The current HR has exceeded the target HR!
The diastolic BP has exceeded the normal
range!
The systolic BP has exceeded the normal range!
Sorry, Can not Connect to the DataBase!
Table 10-1 Hint Information and Causes
- 124 -
Causes
Electrodes fall off the patient or the patient
cable falls off the ECG sampling box.
During the pre-sampling course
The sentinel is not installed.
The sentinel is set wrongly.
The USB cable is disconnected or the
communication between the ECG sampling box
and the serial port is interrupted.
1. Reconnect the ECG sampling box to the PC.
2. Click on the Device tab on the System
Setting interface of the PC ECG system, and
check whether the sampling device is set
correctly.
The direct current offset voltage on an electrode
is too high.
Fail to open the COM port which controls the
treadmill/ergometer.
treadmill/ergometer to the PC, and set the COM
port correctly.
Fail to open the COM port which controls the
blood pressure. Reconnect the BP monitor to the
PC, and set the COM port correctly.
Current heart rate value exceeds the target heart
rate value.
Diastolic blood pressure exceeds the normal BP
range.
Systolic blood pressure exceeds the normal BP
range.
MSDE 2000 or SQL Server 2005 Express is not
started up.
Hint Information
Reconnect
the
Advertisement
Table of Contents
