Base Station Top Panel With Leds; Base Station Label - NETGEAR VNC4030-111PAS User Manual

FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual

Base Station Top Panel With LEDs

Three status LEDs are located on the top panel of the base station. The following table describes the LED
status.
Table 1. LED descriptions
LED Description
Power LED Off. No power is supplied to the base station.
Solid green. Power is supplied to the base station and the base station is ready.
Solid amber. The base station is booting.
Blinking green. The base station is upgrading firmware.
Network LED Off. No link with the network is detected.
Solid green. A link with the network is detected.
Solid amber. A network connection problem occurred. The base station is not connected to the
LAN or to the router, the cable is disconnected, or another network problem occurred.
Camera LED Off. No cameras are connected to the base station.
Solid green. One or more cameras are connected to the base station.
Blinking green. The base station and a camera are attempting to synchronize.
Solid amber. A camera is too far from the base station or the signal is weak.

Base Station Label

The base station label, also referred to as the product label, is on the bottom panel. The label shows the
serial number, the MAC address, and other information for the base station.
Figure 4. Base station label
Introduction and Hardware Overview
9