Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
A login window opens.
3.
Enter the base station password.
The password is the one that you specified the first time that you logged in. The password is
case-sensitive.
The Dashboard page displays.
4.
For the camera that you want to configure, click the Settings icon and select Motion Sensitivity >
Calibration.
The Motion Calibration page displays and the camera enters motion detection feedback mode. When
the camera detects motion, its LED blinks so that you can set the motion sensitivity.
5.
Move the slider to set the motion sensitivity.
Start with a lower setting and gradually increase until people are detected when walking into the camera
video frame. You can also tilt the camera down slightly to get the best performance from the motion
sensor.
The default sensitivity setting is 80.
6.
Click the APPLY button.
Your settings are saved.
7.
Click the Close icon.
The Dashboard page displays.
Set the Motion Sensitivity for a Camera
You can set the motion sensitivity for a camera without calibrating the camera.
To set the motion sensitivity for a camera:
1.
Open a web browser from a computer or mobile device that is connected to the same LAN as the base
station.
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable to connect a computer
to the same router or switch as the base station.
2.
Enter the domain name or IP address of the base station.
If you do not know the domain name or IP address, see
page 16.
A login window opens.
3.
Enter the base station password.
The password is the one that you specified the first time that you logged in. The password is
case-sensitive.
The Dashboard page displays.
4.
For the camera that you want to configure, click the Settings icon and select Motion Sensitivity.
The Motion Sensitivity page displays.
Access the Base Station for the First Time
Manage Camera Settings
50
on
Advertisement
Table of Contents
