Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
The base station restarts.
Reset the Base Station to Factory Default Settings
Under some circumstances (for example, if you lost track of the changes that you made to the base station
and camera settings or you move the base station to a different network), you might want to erase the
configuration and reset the base station and cameras to factory default settings.
If you do not know the current IP address of the base station, see
on page 16. Otherwise, first try to use an IP scanner application to detect the IP address before you reset
the base station to factory default settings.
To reset the base station to factory default settings, you can use either the Reset button on the back panel
of the base station or the use the reset function in the local browser interface. However, if you cannot find
the IP address or lost the password to access the base station, you must use the Reset button.
After you reset the base station to factory default settings, the initial password is password, the DHCP client
is enabled, and the fully qualified domain name (FQDN, or just domain name) is http://FlexPowerBS-xxx/,
in which you must replace xxx with the last three digits of the base station serial number. The serial number
is on the base station label.
Note
On a Mac or a computer with a Linux operating system, the domain name is extended
with the .local suffix, as in http://FlexPowerBS-xxx/.local.
For a list of factory default settings, see
Reset the Base Station From the Local Browser Interface
You can reset the base station and camera settings to factory default settings from the local browser interface.
This option is convenient if you cannot easily access the base station or if you access the base station from
a remote location.
CAUTION:
This process erases all settings that you configured for the base station and cameras.
To reset the base station and camera settings to factory default settings from the local
browser interface:
1.
Open a web browser from a computer or mobile device that is connected to the same LAN as the base
station.
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable to connect a computer
to the same router or switch as the base station.
2.
Enter the domain name or IP address of the base station.
If you do not know the domain name or IP address, see
page 16.
A login window opens.
Factory Default Settings
Manage Base Station Settings
40
Access the Base Station for the First Time
on page 67.
Access the Base Station for the First Time
on
Advertisement
Table of Contents
