Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Set the Streaming Duration
Traditional IP cameras stream continuously. Battery-powered, wire-free cameras stream only when motion
is detected. The camera provides two streaming duration modes:
•
Motion detection only. By default, the camera starts streaming when it detects motion and stops
streaming shortly after it no longer detects motion.
•
Motion detection with a set duration.The camera starts streaming when it detects motion and continues
to stream for a period of 10 to 300 seconds, after which the camera stops streaming.
To set the streaming duration for a camera:
1.
Open a web browser from a computer or mobile device that is connected to the same LAN as the base
station.
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable to connect a computer
to the same router or switch as the base station.
2.
Enter the domain name or IP address of the base station.
If you do not know the domain name or IP address, see
page 16.
A login window opens.
3.
Enter the base station password.
The password is the one that you specified the first time that you logged in. The password is
case-sensitive.
The Dashboard page displays.
4.
For the camera that you want to configure, click the Settings icon and select Video Settings > Streaming
Duration.
The Streaming Duration page displays.
5.
Select one of the following radio buttons:
•
Until Motion Stops. The camera streams until shortly after it no longer detects motion. This is the
default setting.
•
Set Duration. Move the slider to set the duration for which the camera streams after it detects
motion. You can set a duration from 10 seconds to 300 seconds. By default, the duration is set at
20 seconds.
6.
Click the APPLY button.
Your settings are saved.
7.
Click the Close icon.
The Dashboard page displays.
Access the Base Station for the First Time
Manage Camera Settings
47
on
Advertisement
Table of Contents
