Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Installation Overview
Set up your FlexPower system in the following order:
1.
Install the base station in your network (see
2.
Add one or more cameras to the base station by synchronizing them with the base station (see
Synchronize a Camera With the Base Station
3.
Discover the base station in your network, access the base station for the first time, create a new
password, and perform the initial setup (see
4.
Add one or more cameras to an ONVIF-compliant VMS (see
VMS
on page 17).
Note
Make sure that the VMS can access a storage device in your network so that you can
store and replay the camera video feeds. If no storage device is available, you can
only take snapshots but not play video feeds.
5.
Place the camera or cameras at their permanent locations (see
Detection
on page 19).
6.
Access and test the base station camera feeds (see
on page 21).
After you complete the setup, you can configure and customize the settings for the base station (see
Base Station Settings
Install the Base Station in Your Network
You must install the base station in your network. By default, the DHCP client of the base station is enabled,
allowing a DHCP server or router in your network to assign an IP address to the base station. If you want
to assign a static IP address, see
Install the System Components and Access the Base Station
on page 23) and cameras (see
Assign a Static IP Address to the Base Station
Install the Base Station in Your Network
on page 15).
Access the Base Station for the First Time
Add a Camera to an ONVIF-Compliant
Place a Camera for Optimal Motion
Access and Test the Base Station Camera Feeds
Manage Camera Settings
14
on page 14).
on page 16).
Manage
on page 43).
on page 30.
Advertisement
Table of Contents
