Table of Contents
Advertisement
Introduction and Hardware Overview
This manual is for the NETGEAR FlexPower ONVIF
the FlexPower Base Station for FlexPower Cameras, model VNB4000.
Open Network Video Interface Forum (ONVIF) is an open industry forum for the development of a global standard
for the interface of IP-based physical security products. This standard defines communication between devices
such as FlexPower cameras and base stations, a video management system (VMS), and access control systems.
The FlexPower camera, which you can place indoors or outdoors, streams video only when motion is detected.
The camera can operate for months on a single charge with its rechargeable battery, which you can power with
an optional solar panel or with the power adapter that is supplied with the camera.
The FlexPower base station accepts WiFi streaming video data from FlexPower cameras and delivers the video
data to an ONVIF-compliant VMS such as Milestone Arcus on NETGEAR ReadyNAS. A single base station
supports WiFi streaming from up to four cameras.
The chapter contains the following sections:
•
System Concepts
•
System Requirements
•
Base Station Hardware Overview
•
Camera Hardware Overview
Note
For more information about the topics that are covered in this manual, visit the support website
at netgear.com/support.
Note
Firmware updates with new features and bug fixes are made available from time to time at
downloadcenter.netgear.com. You can check for and download new firmware manually. If
the features or behavior of your product does not match what is described in this guide, you
might need to update your firmware.
®
-compliant Wire-Free IP Camera, model VNC4030, and
5
1
Advertisement
Table of Contents
