Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Camera Hardware Overview
The FlexPower camera synchronizes with the FlexPower base station to send video data streams to the
VMS. The camera comes with indoor and outdoor mounting hardware and a battery, which you can recharge
with the power adapter (included in the package) or a solar panel (not included but available as an option).
Depending on how you use the camera, the battery can operate for months on a single charge. The camera
uses Quick Charge technology. A typical USB charger is not compatible with the camera. Therefore, to
recharge the camera, use only the power adapter and USB cable that are included in the package.
For more information about how to install the camera, see the following guides, both of which are included
in the product package and which you can also download by visiting downloadcenter.netgear.com:
•
FlexPower ONVIF Wire-Free IP Camera Model VNC4030-111PAS Quick Start Guide
•
Wall-Mounting the FlexPower Camera Model VNC4030-111PAS Quick Start Guide
Camera Package Contents
The package for the camera contains the following items:
•
FlexPower camera
•
Rechargeable battery
•
Power cable
•
Power adapter
•
Outdoor mount
•
Outdoor mount plate
•
Magnetic wall mount
•
Mounting screws (two sets of two screws)
•
Drywall anchors
•
Quick start guide (not shown in the following figure)
Figure 5. Camera package contents
Introduction and Hardware Overview
10
Advertisement
Table of Contents
