Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Insert the Battery
Figure 6. Insert the battery
The rechargeable battery is fully charged when the camera leaves the factory.
For information about recharging the battery, see the FlexPower ONVIF Wire-Free IP Camera Model
VNC4030-111PAS Quick Start Guide, which is included in the product package or which you can download
by visiting downloadcenter.netgear.com.
To insert the battery:
1.
Unlock the battery compartment by pressing and holding the latch.
2.
Gently pull the battery door back to open the compartment.
3.
Align the battery contacts.
4.
Insert the battery.
5.
Close the battery door.
Camera LED and SYNC Button
Figure 7. Camera LED and Sync button
The camera provides an LED that indicates the general, synchronizing, and charging state of the camera
(see the following table). The camera also provides a SYNC button that lets you add the camera to (that is,
Introduction and Hardware Overview
11
Advertisement
Table of Contents
