Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
The back panel of the base station provides the following components (listed from left to right):
•
DC power receptacle. A DC power receptacle for the power adapter that is included in the product
package.
•
On-Off power button. A power button that lets you turn the base unit on or off.
•
LAN port. An RJ-45 Ethernet port to connect the base station to your LAN.
•
USB2 port. A USB 2.0 port labeled USB2. This port is disabled and might be enabled in a future update.
•
USB1 port. A USB 2.0 port labeled USB1. This port is disabled and might be enabled in a future update.
•
Reset button. A recessed button that lets you reset the base station to factory default settings. For
more information, see
Base Station Front Panel
Figure 3. Base station front panel
The front panel of the base station provides the SYNC button that lets you synchronize a FlexPower camera
with the base station. For more information, see
Reset the Base Station by Using the Reset Button
Synchronize a Camera With the Base Station
Introduction and Hardware Overview
8
on page 41.
on page 15.
Advertisement
Table of Contents
