Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
Change the Base Station Password
The first time that you logged in to the base station, you were required to change the password for the base
station. You can change this password again. The password applies to the local browser interface for the
base station only.
In addition to alphanumeric characters, you can use the following special characters in a password:
! " # $ % & ( ) * + , - . / : ; < = > ? @ [ \ ] ^ { | } ~ and a space. However, a space is not allowed at the beginning
and at the end of a password. A password can be a maximum of 32 characters.
To change the password for the base station:
1.
Open a web browser from a computer or mobile device that is connected to the same LAN as the base
station.
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable to connect a computer
to the same router or switch as the base station.
2.
Enter the domain name or IP address of the base station.
If you do not know the domain name or IP address, see
page 16.
A login window opens.
3.
Enter the base station password.
The password is the one that you specified the first time that you logged in. The password is
case-sensitive.
The Dashboard page displays.
4.
Click the Main Menu icon and select Change Password.
The Change Password page displays.
5.
Enter your current password, enter a new password, and confirm the new password.
6.
Click the CHANGE PASSWORD button.
Your settings are saved. You must log in again to the local browser interface using your new password.
Manage Emails and Notifications
After you specify the SMTP server settings for outgoing email and set up one or more email address recipients,
you can configure the base station to send email notifications if a low-battery condition or weak signal occurs
for a camera, if a camera goes offline, or if new firmware is available.
Configure the Base Station SMTP Server Settings
Before you can let the base station send email notifications, you must configure the Simple Mail Transfer
Protocol (SMTP) server settings for outgoing email.
Some email providers might require extra security steps to enable SMTP for the email account. To find out
about the SMTP server requirements, we recommend that you visit the support site for your email provider
before you configure the SMTP server settings on the base station.
Manage Base Station Settings
26
Access the Base Station for the First Time
on
Advertisement
Table of Contents
