Table of Contents
Advertisement
FlexPower ONVIF Wire-Free IP Camera and Base Station User Manual
3.
Enter the base station password.
The password is the one that you specified the first time that you logged in. The password is
case-sensitive.
The Dashboard page displays.
4.
Click the Main Menu icon and select Configuration Manager > Factory Reset.
The Factory Reset page displays.
5.
Click the FACTORY RESET button.
A confirmation request displays.
6.
Click the OK button.
The base station resets to factory default settings.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, do not close the browser, click a link, or load a new page. Do not
turn off the base station. Wait until the base station finishes restarting and
the Power LED turns solid green.
For information about how to log in to the base station, see
on page 16.
Reset the Base Station by Using the Reset Button
You can use the Reset button to return the base station and camera settings to factory default settings. The
Reset button is located on the back panel (see
CAUTION:
This process erases all settings that you configured for the base station and cameras.
To reset the base station and camera settings to factory default settings using the Reset
button:
1.
On the back panel of the base station, locate the recessed Reset button.
2.
Using a straightened paper clip, press and hold the Reset button for at least five seconds.
3.
Release the Reset button.
The configuration is reset to factory default settings. When the reset is complete, the base station reboots.
Base Station Back Panel
Manage Base Station Settings
41
Access the Base Station for the First Time
on page 7).
Advertisement
Table of Contents
