Table of Contents
Advertisement
• Community Name
(Read/Write)
• Trap Destination Address
• Trap Destination
Community Name
• SNMPv3
• User Name
• Auth Protocol
• Auth Key (8-32 Characters)
• Priv Protocol
• Priv Key (8-32 Characters)
• Engine ID
• Save/Apply
• Cancel
5.6.4 Backup/Restore Settings
Click "Management Backup/Restore Settings" and the following page will be displayed.
The page includes the following settings:
Object
• Save A Copy of Current
Settings
• Restore Saved Settings
from A File
• Revert to Factory Default
Settings
Enter the password for accessing the SNMP community for read and
write access.
Enter the IP address where SNMP traps are to be sent.
Enter the password of the SNMP trap community.
Enable or Disable the SNMPv3 feature.
Specify the username for SNMPv3.
Select the authentication protocol type: MD5 or SHA.
Specify the authentication key for authentication.
Select the privacy protocol type: DES.
Specify the privacy key for privacy.
Specify the engine ID for SNMPv3.
Click Save/Apply to apply all changes.
Click Cancel to cancel the settings.
Figure 5-51 Backup/Restore Settings
Description
Click Backup to save the current configured settings.
To restore settings that have been previously backed up, click Choose
File to select the file, and click Restore.
Click Factory Default to restore the device to its factory default settings.
-88-
User Manual of WAP-200N/WBS-200N
Advertisement
Table of Contents
