Vpn Pass Through - Planet WAP-200N User Manual

The page includes the following specific settings in PPTP type:
Object
• MTU
• IP Address
• Subnet Mask
• Default Gateway
• PPTP Server
• Username
• Password
• Connect on Demand
• Keep Alive
• Accept
• Cancel

5.4.3 VPN Pass Through

VPN Pass-through allows a secure virtual private network (VPN) connection between two sites. Enabling the
options on this page opens a VPN port and enables connections to pass through the AP without interruption.
Go to the "Operation Mode" page to configure the device as "Client Router" and then go to "Router  VPN
Pass Through" to enable VPN pass through you required in client router mode.
Description
The maximum transmission unit (MTU) specifies the largest packet size
permitted for an internet transmission. The factory default MTU size for
PPTP is 1400. The MTU size can be set between 1200 and 1400.
Enter the device's WAN IP address provided by ISP.
Enter the device's WAN IP subnet mask provided by ISP.
Enter the device's WAN Gateway IP provided by ISP.
Enter the IP address of the PPTP server.
Enter the username provided by ISP.
Enter the password provided by ISP.
Select it to specify the maximum idle time. Internet connection will
disconnect when it reaches the maximum idle time, but it will
automatically connect when user tries to access the network.
Select whether to keep the Internet connection always on, or enter a
redial period once the internet loses connection.
Click Accept to apply the setting.
Click Cancel to cancel the setting.
Figure 5-28 VPN Pass Through
-65-
User Manual of WAP-200N/WBS-200N