Dhcp - Planet WAP-200N User Manual

300mbps 802.11n outdoor wireless ap/cpe
Table of Contents

Advertisement

Options: This section will not be the same depending on the Internet Connection Type.
Refer to settings of each corresponding section from 5.4.2.1 to 5.4.2.4
Domain Name Server (DNS) Address
• Get Automatically From ISP
• Use These DNS Servers
• Primary DNS
• Secondary DNS
WAN Ping
• Discard Ping on WAN
• Accept
• Cancel
5.4.2.1.

DHCP

Select DHCP and the device will automatically obtain IP addresses, subnet masks and gateway addresses from
the ISP.
assigned a different address.
• PPPoE: Point-to-Point Protocol over Ethernet (PPPoE) is used mainly
by ISPs that provide DSL modems to connect to the Internet.
• PPTP: The point-to-point tunneling protocol (PPTP) is used in
association with virtual private networks (VPNs).
Select it to obtain the DNS automatically from the DHCP server.
Select it to set up the Primary DNS and Secondary DNS servers
manually.
Enter the primary DNS server address.
Enter the secondary DNS server address.
Check it to enable pings on the WAN interface or disable to block pings on
the WAN interface.
Click Accept to apply the setting.
Click Cancel to cancel the setting.
-60-
User Manual of WAP-200N/WBS-200N

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wbs-200n

Table of Contents