Router (Wisp Mode Only); Dhcp Server Settings - Planet WAP-200N User Manual

• Priority
• Accept
• Cancel

5.4 Router (WISP Mode Only)

5.4.1 DHCP Server Settings

Go to the "Operation Mode" page to configure the device as "Client Router" and then go to "Router  LAN
Settings" to configure the device's LAN IP settings in client router mode.
On this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device is
connected to the remote AP supplied by wireless ISP.
The page includes the following settings:
Object
• IP Address
• IP Subnet Mask
• Use Router As DHCP
Server
• Starting IP Address
Forwarding state is entered. This delay is provided so that when a new
bridge comes onto a busy network, it looks at some traffic before
participating.
Specify the Priority number. Smaller numbers have greater priority.
Click Accept to apply the setting.
Click Cancel to cancel the setting.
Figure 5-22 DHCP Server Settings
Description
The LAN IP of the AP.
The LAN subnet mask of the AP.
Select it to enable DHCP server. In here the device is acting as a router.
Specify the starting IP address for the DHCP range.
-58-
User Manual of WAP-200N/WBS-200N