Installing The Ap; Figure 3-1 P Oeand Lan Port Connection; Figure 3-2 Finish Installation And Connect To Antennas (Wap-200N Only) - Planet WAP-200N User Manual

3.3 Installing the AP

Please install the AP according to the following steps. Don't forget to pull out the power plug and keep your
hands dry.
Step 1. PoE and LAN port connection:
(1) Remove the bottom cover.
(2) Connect one end of the Ethernet cable into the LAN (Passive PoE) port of the device and the other
end to the PoE port on the PoE Injector.
(3) Connect the power cord with the PoE Injector and plug the other end into an electrical outlet.
(4) Connect the second Ethernet cable into the LAN port of the PoE Injector and the other end to the
Ethernet port on the computer.
Step 2. Attach the antennas onto the antenna connectors of the device and place the bottom cover back into
the device to finish the installation.

Figure 3-2 Finish installation and connect to antennas (WAP-200N only)

Figure 3-1 PoE and LAN port connection
-20-
User Manual of WAP-200N/WBS-200N