GE T60 Instruction Manual page 780

H.1 CHANGE NOTES
Table H–6: MAJOR UPDATES FOR T60 MANUAL REVISION Z1 (Sheet 2 of 2)
PAGE PAGE CHANGE
(Y3) (Z1)
1-1 1-1 Add
1-5 1-5 Update
2-12 2-12 Update
5-25 5-25 Add
5-103 5-103 Update
5-107 5-107 Update
5-282 5-282 Add
Table H–7: MAJOR UPDATES FOR T60 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
5-90 5-90 Add
Table H–8: MAJOR UPDATES FOR T60 MANUAL REVISION Y2
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
All All Delete
1-1 1-1 Update
3-8 3-8 Update
Table H–9: MAJOR UPDATES FOR T60 MANUAL REVISION Y1 (Sheet 1 of 3)
PAGE PAGE CHANGE
(X2) (Y1)
All All Delete
Title Title Update
1-1 1-1 Update
2- 2- Add
H
2- 2- Delete
2-10 2-10 Delete
2-12 2-12 Update
2-21 2-21 Update
3-10 3-10 Update
3-23 3-23 Update
5-1 5-1 Update
5-15 5-15 Update
5-16 5-16 Delete
5-17 5-17 Add
H-4
DESCRIPTION
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-28 and 5-29 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-30 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
Added a reference to the T35/T60 Reference Winding Selection and CT Ratio Mismatch
Application Note in section 5.4.4b General Transformer Settings, specifically the Reference
Winding setting
DESCRIPTION
Minor changes throughout document
Deleted CPU options U and V
Updated Figure 1-1 Rear Nameplate
Updated Figure 3-10 Rear Terminal View
DESCRIPTION
Deleted content pertaining to Ethernet switch
Changed part numbers. Updated address and contact information.
Updated address and contact information
Added CPU options T, U, and V to order code table
Removed E, G, H, J, S from CPU options from order code tables
Deleted 9S, 2S, 2T from replacement module order code Tables 2-7 and 2-8
Changed number of phase distance and ground distance zones to 5 in Protection Elements
section 2.2.1
Updated Ethernet fiber table in section 2.2.8 Communications
Updated Figure 3-12 Typical Wiring Diagram
Deleted references to COM 1 RS485 port in section 3.2.9 CPU Communication Ports. Revised
text and Figure 3-24 CPU Module Communications Wiring to include only modules T, U, V in
section 3.2.9a.
Updated the front panel main menu to include the CyberSentry security menu
Update Communications main menu to remove the SNTP Protocol submenu
Deleted references to COM 1 RS485 port in section 5.2.4b Serial Ports
Added section 5.2.4c Ethernet Network Topology
T60 Transformer Protection System
APPENDIX H
GE Multilin