Table of Contents
Advertisement
Cleaning and Maintenance
The following must be considered during regular service and inspection:
All screws for installing the device or parts of the device must be tightly connected and must not be cor-
l
roded.
There must not be any deformations to the housing, lenses, rigging, and installation points (ceiling, sus-
l
pension, trussing).
Motorized parts must not show any signs of wear and must move smoothly without issue.
l
The power supply cables must not show any damage, material fatigue or sediment.
l
Note:
Further instructions depending on the installation location and usage must be
adhered to by a qualified installer and all safety concerns must be mitigated.
CAUTION:
procedures.
In order to ensure the device remains in good working condition and does not fail prematurely, regular main-
tenance is recommended.
1. Clean the inside and outside lens regularly to avoid loss of output due to accumulation of dust/ dirt on the
lens.
2. Clean the fans regularly to ensure maximum airflow and efficient thermal cooling. This will ensure the
light source is operated in the best possible condition.
Note:
ETC and High End Systems, Inc. recommends frequent cleaning of the device.
Please use a moist, lint- free cloth. Never use alcohol or solvents.
If spare parts are required, order only genuine parts from your local authorized dealer.
Disconnect the fixture from mains power before starting any maintenance
47
Advertisement
Table of Contents
