Table of Contents
Advertisement
Edit Scenes
A parameter is a fixture attribute that can be controlled, for example to modify the light beam in terms of color,
beam quality and pattern, intensity, or focus (position). DMX programming assigns a DMX value to each of the fix-
ture's parameters. A scene is one combination of parameter settings. The SolaFrame 750 fixture provides 250
pre-programmed scenes you can use or edit to build a preset program.
This menu is provided to edit the scenes in the internal auto programs.
1. Press the [MODE/ESC] button to display the main menu.
2. Tap the [Up] or [Down] button until the "Preset" option displays, then press [Enter]. The "Preset" menu dis-
plays.
3. Tap the [Up] or [Down] button until the "Edit Scenes" option displays, then press [Enter]. The "Edit
Scenes" menu displays.
4. Tap the [Up] or [Down] button to cycle through and select from the available scene options (Scene 1,
Scene 2, etc.), then press [Enter]. The "Edit Scenes" menu displays and the fixture responds to the selec-
ted scene.
5. Press the [Up] or [Down] button to scroll the available channel feature and press [Enter]. The channel
value displays for edit.
6. Press the [Up] or [Down] button to change the channel value, then press [Enter].
7. Repeat for each scene if desired. Press [Enter] with each edit.
8. To return to the main menu, press the [MODE/ESC] button.
Scenes Input
This menu allows you to capture scene data, overwriting fixture attribute DMX parameter values, from a
DMX control source.
1. Press the [MODE/ESC] button to display the main menu.
2. Tap the [Up] or [Down] button until the "Preset" option displays, then press [Enter]. The "Preset" menu dis-
plays.
3. Tap the [Up] or [Down] button until the "Scenes Input" option displays, then press [Enter]. The "Scenes
Input" menu displays.
4. Press the [Up] or [Down] button to select the start scene number and the [Left] or [Right] button to select
the end scene number. With each change of any DMX value, as received by the DMX control source, the
capturing scene will advance to the next one in the range.
5. When all scenes have been recorded, the display will return to the main menu.
Note:
While capturing the DMX data from the control source, the SolaFrame 750 does not
playback the DMX input, it only captures the data into the on-board memory. You must edit
or playback the scene after recording to verify the results. Best practice is to prepare the
scenes on a DMX controller with a zero crossfade for all parameters between each step.
Remember that any change of a DMX value will automatically advance to the next scene
for capturing.
38
Advertisement
Table of Contents
