Calibrator Interface - Omega cl310 User Manual

2. Calibrator Interface

Figure 1 shows the location of the input and output connections on
the calibrator, while Table 1 describes their use.
No. Name
1, 2 Measure Isolated V,
mA terminals
3 TC input/output
4,5 Source/Measure
V,RTD 2W, Hz,
6,7 Source/Measure
mA terminals, 3W 4W
8 Pressure module
connector
9 Serial port
Figure 1. Input/Output Terminals
Table 1: Input and Output Terminals
Description
Input terminals for measuring current, voltage,
and supplying loop power.
Terminal for measuring, or simulating thermo-
couples. Accepts miniature polarized thermo-
couple plugs with flat in-line blades spaced 7.9
mm (0.312 in) center to center.
Terminals for sourcing and measuring voltage,
frequency, pulse train, and RTDs
Terminals for sourcing and measuring current,
and performing
RTD measurements with 3-wire or 4-wire
setups.
Connects calibrator to a pressure module for
pressure measurements.
Connects calibrator to a PC for uploading data
or remote control or to a serial printer for print-
ing calibration certificates.
5