Omega cl310 User Manual page 75

the desired test value. For all other output types, enter the output
value to be generated using the numeric keys, followed by ENTER.
If the calibrator input is not manual, wait for the displayed calibrator
input value to settle and then press the NEXT function key to prompt
for the manual entry(s) as described in the following subsection.
If the calibrator input is manual, wait for the external device reading
to settle and then press the NEXT function key to prompt for the
manual entry(s) as described in the following subsection.
Upon return from the manual entry prompts(s), the NEXT function
key label changes to SAVE. If the data displayed is correct, press the
SAVE function key to save the data and step to the next point. The
point number in the upper right increases to show that the test data
is saved. If the manual data must be corrected before saving it, press
the LEFT ARROW key to change the SAVE function key back to
NEXT, and press it to repeat the manual entry(s).
Once the desired number of points have been tested, press the
DONE function key to end the data collection stage and proceed to
the entry of test identification data.
If for any reason the data collection is to be terminated without
saving any data, press either the HOME key or the ABORT function
key. A prompt is displayed requesting confirmation that the test data
accumulated so far is to be abandoned. Press the NO function key
to return to the data collection process at the point where it was
interrupted. Press the YES function key to abandon the data
collected.
Manual Data Entry Prompt
A prompt similar to the following is displayed for entry of manual
inputs and outputs. When both input and output are manual, the
output prompt is displayed first.
Enter the manual value using the numeric keys, followed by ENTER.
If the value is correct, press the DONE function key to continue. The
BACK function key may be pressed to return to the previous prompt
display.
71