Omega cl310 User Manual page 17

3. Using Measure Modes (Lower Display)
3.1 Measuring volts and frequency
Electrical parameters volts and frequency can be measured using
the lower display. To make the desired measurements, follow these
steps:
1. Switch to the lower display [LOWER] from Main Menu.
2. Select the desired parameter for measurement.
3. Connect leads as shown in Figure 5.
Measuring Volts and Frequency with Input/Output Terminals
3.2 Measuring mA
To measure mA follow these steps:
1. Switch to lower display and select mA.
2. Make sure the input/output control is set to IN.
3. Connect leads as shown in Figure 6.
Figure 6. Measuring mA with Input/Output Terminals
3.3 Measuring Temperature
3.3-1 Using Thermocouples
The calibrator supports the following thermocouple types: B, C, E, J,
K, L, N, R, S, T, U, BP , and XK. The characteristics of all the types are
described in Specifications section. The calibrator also has a Cold
Junction Compensation (CJC) function. Normally this function should
Figure 5.
13