Table of Contents
Advertisement
*RST
*SRE
*SRE?
*STB?
*WAI
Command
CAL_START
CJC_STATE
CPRT_COEFA?
CPRT_COEFB?
CPRT_COEFC?
CPRT_MIN_T?
CPRT_MAX_T?
CPRT_R0?
FREQ_LEVEL?
FREQ_TYPE?
FREQ_UNIT?
FUNC?
36
Resets the state of the instrument to the power-up state. This
command holds off execution of subsequent commands until it
is complete.
Loads a byte into the Service Request Enable register.
Returns the byte from the Service Request Enable register.
Returns the status byte.
Prevents further remote commands from being executed until
all previous remote commands have been executed.
Table 6: Calibrator Commands
Description
Puts the calibrator in calibration mode
Turns CJC on or off.
Returns the state of the CJC
Sets the custom RTD coefficient A
Returns the custom RTD coefficient A
Sets the custom RTD coefficient B
Returns the custom RTD coefficient B
Sets the custom RTD coefficient C
Returns the custom RTD coefficient C
Sets the custom RTD minimum temperature
Returns the custom RTD minimum temperature
Sets the custom RTD maximum temperature
Returns the custom RTD maximum temperature
Sets the custom RTD R0 resistance
Returns the custom RTD R0 resistance
Returns the error code of an error that has occurred
Sets the frequency and pulse amplitude
Returns the frequency and pulse amplitude
Set the frequency output to continuous (frequency) or
pulse.
Returns frequency output type, continuous or pulse
Sets the unit for frequency and pulse
Returns the unit for frequency and pulse
Returns the current mode of the upper and lower dis-
play
Returns the calibrator date and time setting
Returns the calibrator serial number
- Quick Links:
- Calibrator Interface
- Rtd_Type
- Specifications
Hide quick links:
Advertisement
Table of Contents
