NETGEAR MS510TXPP Installation

Installation
NETGEAR 8-Port Multi-Gigabit Smart Managed Pro Switch
with two 10G Ports, Model MS510TX
NETGEAR 8-Port Multi-Gigabit Smart Managed Pro Switch
with PoE+ and two 10G Ports, Model MS510TXPP
Package Contents
• NETGEAR Smart Managed Pro Switch Model MS510TX or MS510TXPP
• AC power cord (localized to country of sale)
• Rubber footpads for tabletop installation
• 19-inch rack-mount kit for rack installation
• Resource CD
• Installation guide
Configure the Switch With a Static IP Address
Note: If your network uses a DHCP server, this section does not apply.
Go directly to Connect the Switch to a
If you are using static IP addresses in your network, configure the switch IP
address before you connect the switch to a network.
1. Configure a computer with a static IP address in the 192.168.0.x subnet.
2. Plug the switch into a power outlet and connect your computer to the
switch using an Ethernet cable.
3. Open a web browser and enter 192.168.0.239 in the address bar.
The default IP address of the switch is 192.168.0.239.
A login page displays.
4. Enter password for the password.
The System Information page displays.
5. Select System > Management > IP Configuration.
The IP Configuration page displays.
MS510TX
6. Select the Static IP Address radio button.
MS510TXPP
7. Enter the static IP address, subnet mask, and default gateway IP address
that you want to assign to the switch.
8. Click the Apply button.
Your settings are saved.
Connect the Switch to a Network
1. Connect devices to the RJ-45 network ports on the switch front panel. For
model MS510TXPP only, you can connect PoE and non-PoE devices.
For 5G and 10G connections, use Cat 6, Cat 6a, or Cat 7 Ethernet cables
terminated with RJ-45 connectors.
2. Connect an RJ-45 port or SFP+ port on the switch to a network that
includes a DHCP server.
Note: In a small office or home office network, connect the switch to the
LAN port of a router that, in turn, is connected to an Internet modem.
If you use an SFP+ port, you must insert an SFP+ transceiver module, which
is available from NETGEAR.
3. Power on the switch and wait two minutes.
Network.
(PoE links for
MS510TXPP only)
2.5G PoE link
to WAC740 AP
Check the PoE Status (MS510TXPP Only)
Model MS510TXPP can provide PoE+ power on ports 1–8. The switch can
supply up to 30W PoE+ (IEEE 802.3at) to each port, with a maximum PoE
power budget of 180W across all active PoE+ ports.
The PoE Max LED indicates the status of the PoE budget on the switch:
•
•
•
Configure the Switch
You can configure the switch either by using a computer's web browser or by
installing the Smart Control Center Utility (see
your Windows-based computer.
Sample connections
Internet
MS510TXPP
10G non-PoE uplink
2.5G non-PoE link 2.5G non-PoE
to 2.5G gaming link to 2.5G NAS
computer
Off. Sufficient (more than 7W of) PoE power is available.
Solid amber. Less than 7W of PoE power is available.
Blinking amber. At least once during the previous two minutes, less than
7W of PoE power was available.
Smart Control Center
Network
router
Core
switch
5G non-PoE link to
two 2.5G servers
Utility) on