Switch Default Settings - NETGEAR MS510TX User Manual

Switch Default Settings

Table 75. Switch default settings
Feature
Auto negotiation/static
speed/duplex
Auto MDI/MDIX
802.3x flow control/back pressure
Port mirroring
Link aggregation groups (LAGs)
802.1D spanning tree
802.1w RSTP
802.1s spanning tree
Static 802.1Q tagging
Learning process
Storm control per each packet type
(unicast, broadcast, multicast)
Jumbo frame
Number of queues
Port based
802.1p
DSCP
Rate limiting
802.1x
MAC ACL
IP ACL
IPv6 ACL
Password control access
Management security
Smart Managed Pro Switches MS510TX and MS510TXPP
Sets Supported
All ports
N/A
1 (per system)
1 destination port and 8 source ports
8
1
1
16 instances
256
Supports static and dynamic MAC
entries
All ports
All ports
8
N/A
8
64
All ports
All ports
164 (shared with IP and IPv6 ACLs)
164 (shared with MAC and IPv6 ACLs) All IP addresses allowed
164 (shared with IP ACL and MAC
ACL)
1
1 profile with 20 rules for
HTTP/HTTPS/SNMP access to allow
or deny an IP address or subnet
Hardware Specifications and Default Settings
Default Setting
Auto-negotiation
Enabled
Disabled
Disabled
Preconfigured
Disabled
Enabled
Disabled
Default VLAN ID = 1
Dynamic learning is enabled by
default
Disabled
Enabled.
Maximum frame size is 10 KB
N/A
N/A
Enabled
Disabled
Disabled
Disabled
All MAC addresses allowed
All IP addresses allowed
Idle time-out is 10 minutes
The password is password
All IP addresses allowed
349