NETGEAR MS510TX User Manual page 179


To add an IPv6 global address to an IPv6 VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> IPv6 > Advanced > IPv6 Addresses.
The table contains both IPv6 link-local addresses and IPv6 global addresses that were
manually added to the IPv6 VLAN.
6. From the Interface menu, select the VLAN.
7. For the IPv6 Prefix field and the Prefix Length field, either select the check box for a
preconfigured IPv6 address, or specify a new IPv6 address by entering an IPv6 prefix and
prefix length in the global address format.
8. From the EUI64 menu, select Enable or Disable to indicate whether the specified 64-bit
unicast prefix is enabled.
The default value is Disable.
9. Click the Add button.
The IPv6 address is added to the VLAN.
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Routing
Access the Switch
179
on page 12.