Reed Valve - KYMCO MOVIE 125 Manual

19
. EXHAUST EMISSION CONTROL
SYSTEM

REED VALVE

REMOVAL
1. Remove the frame center cover.
2. Remove the floor board.
3. Disconnect the secondary air inlet tube
connector.
4. Remove the four cylinder head cover
bolts and two secondary air outlet tube
bolts.
INSPECTION
1. Remove the two bolts attaching the reed
valve cover and the reed valve.
2. Check the reed valve for cracks, damage,
big clearance or weak reeds. Replace if
necessary.
3. Check the gasket and O-ring for damage
or deterioration and replace if necessary.
4. Reed valve stopper clearance: 4.6mm
INSTALLATION
Install the reed valve in the reverse order of
removal.
＊
• When installing, be careful not to bend
or twist the tubes and check for
proper installation.
19-6
Secondary Air Inlet
Tube Bolt
Reed Valve Cover Bolts
Reed Stopper
Cylinder Head Cover Bolts
Bolt