Stop Switches; Horn Inspection; Fuel Gauge; Fuel Unit - KYMCO MOVIE 125 Manual

17
. LIGHTS/INSTRUMENTS/SWITCHES
STOP SWITCH
INSPECTION
Remove the handlebar front cover. ( 2-4)
Disconnect the front stop switch wire
coupler.
Check for continuity between the wire
terminals when the front brake lever is
applied. The switch is normal if there is
continuity.

HORN INSPECTION

Remove the front cover. ( 2-4)
Disconnect the horn wire coupler.
The horn is normal if it sounds when a 12V
battery is connected across the horn wire
terminals.

FUEL GAUGE

INSPECTION
Remove the rear right side cover. ( 2-2)
Disconnect the fuel gauge wire connector.
Turn the ignition switch ON.
Connect the green and yellow/white wires and
the fuel gauge needle should move from E to
F.
Connect the green and blue/white wires and
the fuel gauge needle should move from F to
E.

FUEL UNIT

REMOVAL
Remove the met-in box. ( 2-3)
Remove the rear right side cover. ( 2-2)
Disconnect the fuel unit wire connector.
Remove the fuel unit.
＊
Be careful not to bend or damage the fuel
unit float arm.
17-5
Green
Yellow/White
Fuel Unit Connector