Auto Bystarter - KYMCO MOVIE 125 Manual

17
. LIGHTS/INSTRUMENTS/SWITCHES
INSPECTION
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
RESISTANCES
Float
Color
G_ Y/W
G_ L/W
Y/W_ L/W 480_
The installation sequence is the reverse of
removal.
＊
• Install the fuel unit by aligning the
groove on the fuel unit with the tab on
the fuel tank.
• Align the arrow on the fuel unit retainer
with the arrow on the fuel tank.

AUTO BYSTARTER

AUTO BYSTARTER INSPECTION
Remove the rear right side cover. ( 2-2)
Disconnect the auto bystarter wire connector.
Measure the resistance between the yellow
and green/black wire terminals.
Resistance: 10W max.
＊
Perform this operation when the engine
is cold.
RESISTOR INSPECTION
Remove the front cover. ( 2-4)
Disconnect the green/black and green wires
and measuring the resistance between the wire
terminals.
Resistance: 5W max.
If the needle remains at "•", it indicates that
the resistor is faulty and must be replaced.
Unit: W
Upper Lower
35_ 45 480_
480_ 520 35_
520 480_
520
45
520
Auto Bystarter Resistor
Auto Bystarter
Connector
17-6