Headlight; Front Turn Signal Light - KYMCO MOVIE 125 Manual

17
. LIGHTS/INSTRUMENTS/SWITCHES

HEADLIGHT

BULB REPLACEMENT
Remove the front cover. ( 2-4)
Remove the rubber boot from the bulb socket.
Remove the bulb socket by turning it counter-
clockwise.
Remove the bulb for replacement.
Install a new bulb, aligning the groove on the
bulb socket with the tab on the bulb.
Install the bulb socket.
Install the rubber boot.
Install the front cover. ( 2-4)
Rubber Boot Bulb Socket
HEADLIGHT REMOVAL
Remove the front cover. ( 2-4)
Remove the six screws attaching the
headlight.
Remove the headlight.
The installation sequence is the reverse of
removal.
After installation, adjust the headlight beam.
( 3-9)
Screws

FRONT TURN SIGNAL LIGHT

Remove the front cover. ( 2-4)
Remove the front turn signal bulb socket and
replace the bulb.
The installation sequence is the reverse of
removal.
Turn Signal Bulb Sockets
Position Light Shell
POSITION LIGHT/REAR TURN
SIGNAL LIGHT
BULB REPLACEMENT
Remove the rear cover. ( 2-2)
Remove the two screws to remove the
position light/rear turn signal light shell.
Remove the bulb sockets and replace the
bulb.
The installation sequence is the reverse of
removal.
Screws
17-2