9. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
Check the clutch shoes for wear or damage.
Measure the clutch lining thickness.
Service Limit: 1.5mm replace if below
CLUTCH/DRIVEN PULLEY
DISASSEMBLY
Hold the clutch/driven pulley assembly with
the clutch spring compressor.
*
Be sure to use a clutch spring
compressor to avoid spring damage.
Special
Clutch Spring Compressor
Outer Driver, 32x35mm
Set the clutch spring compressor in a vise and
remove the clutch drive plate nut.
Special
Lock Nut Wrench, 39mm
Loosen the clutch spring compressor and
disassemble the clutch/driven pulley
assembly.
Remove the seal collar.
9-9
Clutch/Driven Pulley
Clutch Spring Compressor
Lock Nut Wrench