KYMCO MOVIE 125 Manual page 106

9. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
Install the drive pulley face, starting ratchet
and drive face nut.
＊
When installing the drive pulley
•
face, compress it to let the drive belt
move downward to the lowest position
so that the drive pulley can be
tightened.
Install the starting ratchet by
•
aligning the starting ratchet teeth with
the crankshaft teeth.
Hold the drive pulley with the universal
holder and tighten the drive face nut.
Torque: 5.5kg-m
Special
Universal Holder
＊
Do not get oil or grease on the drive belt
or pulley faces.
CLUTCH/DRIVEN PULLEY
Remove the left crankcase cover. ( 9-2)
Remove the drive pulley and drive belt.
( 9-3)
Hold the clutch outer with the universal
holder and remove the clutch outer nut.
Special
Universal Holder
Remove the clutch outer.
INSPECTION
Inspect the clutch outer for wear or damage.
Measure the clutch outer I.D.
Service Limit: 125.5mm replace if over
Drive Pulley Face
Drive Face Nut Starting Ratchet
Drive Pulley
Clutch Outer
Universal Holder
Universal Holder
9-8