Displaying And Maintaining Qinq; Qinq Configuration Examples; Basic Qinq Configuration Example - HP FlexFabric 12900 Series Configuration Manual

Step
9. Associate the traffic class
with the traffic behavior in
the QoS policy.
10. Return to system view.
11. Enter Layer 2 Ethernet
interface view.
12. Configure the port to trust
the 802.1p priority in
incoming frames.
13. Enable QinQ.
14. Apply the QoS policy to the
inbound direction of the
port.
For more information about QoS policies, see ACL and QoS Configuration Guide.

Displaying and maintaining QinQ

Execute the display command in any view.
Task
Display QinQ-enabled ports.

QinQ configuration examples

Basic QinQ configuration example

Network requirements
As shown in
The service provider assigns VLAN 100 to Company A's VLANs 10 through 70.
•
• The service provider assigns VLAN 200 to Company B's VLANs 30 through 90.
The devices between PE 1 and PE 2 in the service provider network use a TPID value of 0x8200.
•
Configure QinQ on PE 1 and PE 2 to transmit traffic in VLANs 100 and 200 for Company A and
Company B, respectively.
For the QinQ frames to be identified correctly, set the SVLAN TPID to 0x8200 on the service provider-side
ports of PE 1 and PE 2.
Command
classifier classifier-name behavior
behavior-name
quit
interface interface-type interface-number
qos trust dot1p
qinq enable
qos apply policy policy-name inbound
Figure 44:
Command
display qinq [ interface interface-type
interface-number ]
157
Remarks
N/A
N/A
N/A
By default, the device
trusts the priority carried
in frames.
Skip this step if the
remark dot1p
customer-dot1p-trust
command is configured.
N/A
N/A